The Spiritual Sun

[1.1.16] For you to understand these things even better, I will give you clear information by means of a few examples. First, take a small rod of noble metal. If you look at it in its raw condition, it is dark and rough. If you would polish it, however, it will look completely different as before and yet, it is still the very same rod. What then, is the actual reason to beautify this rod? I tell you, it is very simple. By sharpening and polishing it, the parts at the surface of the rod is pressed closer together and is in a certain way, connected to one another. It thus becomes, even more, concrete and mutually stronger adherent to one another and thus, in a certain sense, also completely unanimous. In the initial crude condition where it still was a loose unit, the parts stood almost in animosity towards each other. Every loose part vied for himself to have the nourishing radiation of light, take for himself as much as possible and leave nothing for his neighbor. In the polished state, which could be called a refined or purified state, these parts take hold of each other. By this taking hold of each other, the light beams become the common good, since no one particle wants to keep it for himself, but share every single bit of light with his neighbors. What is the result? All now have abundant light and they are by a long stretch not able to take in all the riches. The abundance of the general beaming riches reflects as a beautiful, harmonious glow from the whole surface of the polished golden rod.

[1.1.17] Do you already suspect where this glow comes from? From the unity, or the unification. If then the spiritual is perfect and united in himself, how much greater will be the glory of the spiritual than that of its body which only consists of pieces and is therefore also selfish, full of self-interest and thus dead!

[1.1.18] Let's have another example. You must have seen a silica stone before, of which glass is produced. Let such a rough silica stone, just like its descendant, the glass, the rays pass through unhindered? O no, this you know very well. Why does such a rough silica stone not let the rays through? Because its parts are still too much separated and too little united. If the rays would fall upon it, every little part would devour the rays for himself and will leave nothing, or in a sense only the waste of the absorbed light for his neighbor. But how is it that his descendant, the glass, becomes so generous? Look first, the silica stone is crushed and ground. This way each particle in a sense dies for the other or gets completely separated from the other. Then the silica powder gets washed, then dried, mixed with salt and then put into the furnace where the separate particles become completely mutually united through the salt and the correct temperature of the fire.

Desktop About us